Hebrew Scribes at the End of the Line

Composing a text by hand demands an awareness of certain details that we can ignore when using a word processor. One of these details is if the next written word corresponds to the available space. At times, the space didn't for Hebrew scribes, and when this happened, they had several ways to navigate this situation. Let’s review some of these. For more information on these practices, see Tov’s discussion in chapters 4 and 5 of his book Scribal Practices. This list depends on and derives in part from his helpful discussions.

First, scribes could utilize the margin to finish the word. This practice is not uncommon. Here is a portion of column 2 of 1QIsaa illustrating this practice.

Second, a scribe could fill in the remaining line with space fillers. The scribe of 1QIsaa resorts to using dots in 1QIsaa Col 3:6.

 

Third, a scribe at times began a word at the end of a line but didn’t finish it. Instead, the word was written in full at the beginning of the next line. Here is an example from 1QIsaa Col 2:11.

 

Fourth, it is possible that the scribe of 1QIsaa began a word and simply failed to finish it. See 1QIsaa Col 6:3.

 

Fifth, a scribe might begin a word at the end of the line and complete it on the next line. Tov states that this was a practice of scrolls written in paleo-Hebrew. 11Q1 Col 3:5, 6, 7 are examples of this.

 

Sixth, a scribe might resort to a smaller “font-size” to fit the word in the available space. See 1QIsaa Col 16:30 (the first line in the photo below).

Seventh, a scribe might write part of the word above the line. Here are some examples from 4QPsx.

 

Eighth, a scribe might cram words together leaving little space between the words. This tendency is common in 4QPsx and here in 1QIsaa Col 16:24.

Ninth, a scribe might leave bigger spaces between letters as here in 4QDeuth 1:5-7. Tov labels this device "proportional" spacing. 

 

These pictures were taken from photos found at the Leon Levy DSS Digital Library and the DSS Digital Project.